Mon–Sun: 7 AM–11 PM(214) 286-6733
Balch Springs ConcreteBalch Springs Concrete

Concrete Contractor in Travis Ranch, TX - Flatwork Built on a Packed Base

Balch Springs Concrete is a concrete contractor working in Travis Ranch, TX, pouring driveways, patios, walks, slabs and footings for homes across the neighborhood, with forms set level and square and the base dug out and packed first.

New concrete driveway curves toward a large brick home, with a white double garage door and landscaped shrubs.
Stamped concrete patio with a reddish border, outdoor dining furniture, and steps beside a brick house.

Travis Ranch as we see it on our jobs

Travis Ranch is a neighborhood in unincorporated Kaufman County, with parks and playgrounds spread through its streets, a main pool that carries the summer and Lake Ray Hubbard along its northwest corner.

Most of our calls here are for flatwork, the driveways, patios and walks around a house, plus steps and the occasional garage floor, much like what we pour in Forney and Rockwall. On these suburban lots the job usually comes down to the ground under the old slab and where the yard sends its water, and on lots toward the lake or low ground, that's the first thing I look at.

What we pour and build in Travis Ranch

How a concrete job in Travis Ranch gets planned

Travis Ranch isn't inside a city, so for most permits we work with Kaufman County's Development Services office instead of a city hall. When a job needs a permit, the pour date waits on it, so I check with the county first, and if a permit is needed we file it, book the inspections and set the pour around them. The state licenses plumbers through the Texas State Board of Plumbing Examiners, so if a line has to move before we pour, that part goes to a licensed plumber. A contractor doing business in the county under a trade name, other than as a corporation or LLC, files an assumed name certificate with the county clerk, and it's good for 10 years. We're licensed and insured.

We're based in Balch Springs and work across the cities around it, and I come out to every estimate myself, then run the job on site with our crew. The price moves with the size and thickness of the slab, how much old concrete comes out, how much digging and base the ground needs, the finish you pick and whether floodplain paperwork or a surveyor comes into it. The schedule turns on any permit and inspections, then on curing, the wait while the slab gains strength before you walk or drive on it. When I walk your job, I measure it and write down what the price covers, so you see your own number and what's in it.

  • Phase 1H of the neighborhood is platted inside the City of Forney's ETJ, the area just outside its city limits, so I look up which side of that line a lot sits on before anything gets filed.
  • A new slab foundation on a flood-zone lot needs an Elevation Certificate, and in Zone AE it reports the lowest floor at least 2 feet above the base flood elevation, the height FEMA's maps put a 100-year flood at. In Zone A it's 2 feet over FEMA's estimate or the best data available, so we set the grade and form height from that before we dig.
  • If the budget gets tight, I'd rather trim the finish than the base, because the dug-out, packed base is buried on day one and it decides whether the slab settles with the dirt later.
  • We cut control joints soon after the pour, grooves that give the slab a planned place to crack, so shrinkage cracks run straight along them instead of wandering across your driveway.
  • Before the forms go up I check where water runs on your lot, so the slab falls away from the house instead of sending rain toward your foundation or pooling it at the garage door.

Get a written estimate for your Travis Ranch concrete job

Tell us what you want poured or fixed and where it sits on the lot, or call (214) 286-6733, and we'll reply within one business day to set a time. I come out myself, walk and measure the job and write down what the price covers, and the estimate is free with no obligation.

(214) 286-6733

Questions Travis Ranch homeowners ask about concrete work

Do I need a permit to pour concrete in a flood zone in Travis Ranch?

Yes, if your lot is in a FEMA Special Flood Hazard Area, Kaufman County issues a floodplain permit for any development there, and paving, grading, filling and digging all count. The county's floodplain office sets the fee by the size of the project, and the application needs an Elevation Certificate from a surveyor or engineer. If your job needs one, we handle the filing.

How do I find out if my house in Travis Ranch is in a flood zone?

Kaufman County's GIS map, on its Development Services site, shows a property's FEMA flood zone and whether it sits in a city's ETJ, and you can search it by full address or property ID number. The county says that data is always being corrected and updated, so I check it again when I come out to look at your job.

Does an electrician need a license in Travis Ranch, TX?

Yes, Texas requires anyone doing electrical work in the state to be licensed, including in unincorporated areas like Travis Ranch, with a few listed exemptions. Wiring in, on, outside or attached to a house counts, so lights along a new patio or outlets by a new garage slab go to a state-licensed electrician.

Service areas

These are the cities around Balch Springs with their own page on our site, and we work in others nearby too, so call if yours isn't listed.

Call or send us your job details

We answer from 7 AM to 11 PM seven days a week, so you can reach us at (214) 286-6733 after work or send the form tonight.

If you're weighing a new driveway, patio or slab in Travis Ranch, send us a message and we'll talk it through.

Tell us about your project
(214) 286-6733Get an estimate